Software updates for Raymarine products are not currently available.
Please visit this page at a later date to download any updates.
IMPORTANT TERMS OF DOWNLOADING SOFTWARE
Firmware update processes are done at your own risk. Before initiating the update process be sure to backup and make copies of all important files.
If the firmware process is interrupted your product may not function properly, therefore do not interrupt the process and ensure the unit is on a reliable power supply. Damage caused by incomplete upgrades will not be covered by Raymarine warranty.
By Downloading the software, you agree to these terms.
Fixed an intermittent detection of the DST800 Smart Transducer, when performing the Calibration process.
Added the ability to select Engine Trim in the bespoke engine pages
Bug fix for Translations - Italian word for "Alarm" corrected
Honda ECO mode has now been implemented in the Engine Data pages. The ECO mode is only supported if a compatible Honda engine is directly interfaced via NMEA2000 (it is not supported via an ECI-100 v1.20)
Bug Fix for Translations, where some pages were not accessible in certain Languages
Supports the calibration of the P79s (NMEA2000) In-Hull Depth Smart Transducer
Now fully compliant with the NMEA2000 standard
The choice of STW or SOG can now be selected in the Engine Overview Data Pages
General other software enhancements
Various improvements and fixes
Speed Calibration process now improved to include three levels. (Single point, Add Points & Advanced)
Analogue Rudder Angle dial can now be displayed as a full page
Added Translation changes to reflect new features and Language corrections
MOB pop up Page added & Alarm can be silenced
AIS SART targets now displayed correctly
Gear Transmission Oil Temperature & Pressure now displayed correctly
Corrections & Enhancements to the MDS (Multiple data Selection) functionality
General corrections to calculated navigation data such as CMG & CTS
Depth Alarms now cancelled on any display globally
Graphic History Pages now show vertical scale
Fuel Flow Rate Bar can now be selected
About System added to Diagnostic Menu. Will search & display devices found on STNG
Full compatibility with the new Instrument Transducer Converter (ITC-5)
This will allow full Calibration and set-up of all Transducer variants supported by the ITC-5
Corrects a fault when Turkish Language is selected, where the i70 could lock up or reset
Modification to Temperature calibration
The TRIP value can now be reset. The Trip value has the following functions:
i70 & Speed Pod – Trip stored in i70 and is individual to each display.
i70 & DST800 – Trip stored in DST and is a single global Trip.
i70 & ITC-5 – Trip stored in ITC-5 and is a single global Trip.