Important note: This release includes both Application and Bootloader. Please make sure both are installed. Once you have installed the Bootloader, you have to re-install the Application code.
See the README included in the download in G Series and a/c/e/gS Series MFD's
Software updates for Raymarine products are not currently available.
Please visit this page at a later date to download any updates.
IMPORTANT TERMS OF DOWNLOADING SOFTWARE
This firmware update process is done at your own risk. Before initiating the update process be sure to backup and make copies of all important files.
If the firmware process is interrupted your product may not function properly, therefore do not interrupt the process and ensure the unit is on a reliable power supply. Damage caused by incomplete upgrades will not be covered by Raymarine warranty.
By Downloading the software, you agree to these terms.
App v1.12 Bootcode v1.14
Accuracy of the Wind Speed calibration of the RotaVector has been improved.
The default Wind calibration factor is now correct for use with the current Mast head unit.
Resolution of the rudder bar output has been increased to provide a smoother needle movement on an i70 or MFD.
Corrects an issue with the depth function where depth data was output onto the STNG bus when a Depth Transducer was not connected.
Allows speed points to be set to SOG when calibrating the Transducer with an i70 using v2.17 (or higher) software.
Corrects an issue that could intermittently cause the unit to fail to start-up.
Corrects an issue that could cause intermittent or no wind data.
Note: Downloading software to the ITC-5 will reset the Transducer calibration settings. Once the Bootloader file has been installed, you then have to re-install the Application file.